More than 50,000 products in stock. Shipping within 24 hours.
More than 50,000 products in stock. Shipping within 24 hours.
Spray for marking metals
Garantované doručenie do 48 hod
Ponúkame len overené značky
Dlhoročné skúsenosti v daných značkách
Pracovné dni 9-16:00
By buying this product you can collect up to
10
loyalty points
.
Your cart will contain total
10
points
that can be converted into a voucher of
€1.00
.
Spray for black metal marking. Suitable for carbon steel and stainless steel, partially applicable to other metals, but must be tested.
It is applied to the surface of the material, allowed to dry and then laser engraved through this coating. When exposed to the laser, it creates highly resistant black marks on all metals. The surface is then cleaned with water. The new targeted soft spray system makes the sprayer equally suitable for spraying small and large areas.
The content of 1 spray of MarkSolid LMM 114 - 300 ml is sufficient for applying the material to an area of ~ 2.25 m2.
This number is valid in theory because it is based on a constant thickness of 30 μm in the whole area.
In practice, it should be possible to reach> 1.5 m².
Packaging: 300 ml
Warning: The spray will not stick to metals that have a coating on the surface. The surface must be raw - natural. Adhesion also depends on the chemical composition of the metal - a test must be performed on each metal.
Specific References
Double-layer plastic with a thickness of 1.6 mm, also suitable for the exterior.
Quality 2-layer material - special acrylic with a durable micro surface.
It is suitable for laser and mechanical engraving and cutting.
Thickness: 1.6 mm
Dimensions: 610 x 610/1220 x 610 mm
Usage: interior / exterior
Classic odorless laser rubber
Dog tag made of anodized aluminum suitable for pore
Double-layer plastic with a thickness of 0.8 mm suitable for interiors.
Quality 2-layer material - special acrylic with a durable micro surface.
It is cost-effective and suitable for laser and mechanical engraving and cutting.
Thickness: 0.8 mm
Dimensions: 610 x 610/1220 x 610 mm
Usage: interior
Business cards made of anodized aluminum suitable for engraving
1 pack includes 10 pieces
Hardened cardboard suitable for engraving and cutting
LMM 6000 Metal marking paste - dilutable with alcohol
LMM 6000 Metal marking paste - dilutable with alcohol
Spray for marking metals
Aluminum oxide is used to blacken the engraving of aluminum
Laser marking spray for metal
Metal marking tape
Metal Oxidizer is used to blacken the engraving on brass
Pliers for rounding corners with a radius of 5 mm
Quality hard anodized aluminum suitable for laserengraving with a thickness of 1 mm
Spray for marking metals
Slovenčina
Čeština
